Thanks for the thoughts so far. I've got about 12 yrs as a machinist/tool and diemaker. I'm sure I didn't leave a burr w/ ASD and to tell the truth, these washers which I checked w/ dial calipers for thickness and parallelism appear more to be machined than stamped. The wobble was/is minor, but enough to throw them off 2-3" at 30 yds. I did learn the tighter the better. Gonna borrow a buddies arrow staightener and see if I can rig the dial indicator up so it will check the run out on the point. More to follow, lol.