PVC FEEDERS
have a couple of 4" pvc feeders, but they are easy to get knocked around on the trees, and sometimesendup sliding up or down higher than I want them. Main problem though is that they don't hold enough. Mine are about 5' long, with cap on top, and either a "Y" fitting close to bottom, or sometimes I just cut lower end half way into, heat and form a sort of funnell to dampen the flow out. Is there any other designs that you guys use that have worked well? Have made them out of 6" pvc before, and they hold more, but the schedule 40 grade 6" pvc is a little expensive for the fittings. Have a tripod feeder out, but would like to set up another site or two without going to the tripod expense. Just wondered if you guys used them, and how you made them.