cascadedad

The 12 guage bore brush is what I often use, they also make a bore with a wire handle to reach in there. If you do not use grease then either brush will pick up the remanents of the tape and pull it out, if you use grease make sure the female and male threads are clean before putting the tape on, and if you do use grease a little bit goes along ways. I have shot up to 40 rounds and never touch the breech plug until I get home and it comes out quite easy IF you got the seal at the face of the breech plug and the barrel flange - that why I tell you snug - tight - not even finger tight - snug. Here is a hand drawn picture of what I am talking about, hope you can figure it out



You can double click this or follow the link below


http://img.photobucket.com/albums/v130/sabotloader/BreechPlug2.gif

The trigger comes off piece of cake - but I am sure that cayugad has covered that.