1. universal decapping die
2. tumbler
3. clean primer pocket
4. inspect
5. resize
6. inspect
7. trim (tumbling afterwards is optional)
8. new primer
9. inspect
10. powder charge
11. bullet
12. weigh and inspect
13. box and label
14. shoot
15. repeat

If I'm starting with a new batch of brass I seperate them by manufacturer. Then I resize and trim every one of them. After that I seperate the "same manufacture" brass by weight.

when I'm loading for my "groundhog gun" I really get picky. For this gun, I weigh every single powder charge. I also have a tweezers... I add/remove a single pellet of powder until I reach the correct weight... ok... maybe I get a little fanatical with this load!!

~Happiness is flying brass! -Country Boy