RE: Lee dies messing up?
Okay, I think I got the issue under control but here is exactly what is happening:
I feed the case up into the die. The pin that de-primes the case fits into the neck and flash hole just fine. However, when I try to take case out of the die the bulge in the "pin" as I'm calling it (the bulge that makes sure the inside neck diameter is acceptable) gets stuck...so much so that it yanks the pin (the 'bulge' and pin are same piece of metal) right out of the die. I'm left with a case with pin stuck in it that has to be wiggled out of the neck.
A little clearer?[&:]