ORIGINAL: viper4358
I have managed to screw up my Tribute! After trying to adjust for ATA, I have gotten my cams severely out of sync. The Tribute is supposed to have 2 dots showing on the outside of the limb and I now have 4 showing on the top cam and 1 showing on the bottom. I tried to reverse what I had done, but I obviously forgot which cables I had twisted. The cam has a post for the string and 2 posts (1 inner and 1 outer)for the 2 buss cables. Does anyone know which post I need to adjust to rotate the top cam torwards the limb and the bottom one away from the limb? Because they are slaved to each other a single adjustment will move both cams.
First get your axle to axle within specs. Then start working the forward cables one at a time. You need to turn the bottom forward cable counter-clockwise (lengthen cable)at least4 twists and that's counter clockwise viewing it from the end of cable. Then your going to need to turn the upper forward cable clockwise (shorten cable)about 3 twists. Basically the longer you makethe cable the more dots will show past limbs. The tighter or shorter you make the cable the less dots show past limb. Make the appropriate twists to get your 2 dots dead on, even if it requires just a half turn. Try your best to keep equal amount of twists in each cable.
If you get to a point that the cables are hard to slip on the cable end supports. b-line the cable straight to the cable supports, then slip the cable up and over onto the cable channel on cam.