My luck contiues. Went to the range this morning to try the Encore with the new steel T/C scope base, the APP powder and the Barnes bullets. I shot the first shot with 777 to check point of impact, not even on the paper. Shot again, same thing. Thought maybe the new base cured the problem I had with the gun shooting low so I pulled it to remove the shims and found the two rear screws broken off. I didn't tighten any tighter then I normally would even though these where torx screws. Now I have two broken off screws to remove.
Anybody know what tap and Easyout to use?
Anybody want to buy an Encore muzzle loader barrel