HuntingNet.com Forums - View Single Post - General Muzzloader Questions - Newbie
View Single Post
Old 07-25-2005 | 10:36 AM
  #3  
1shotkill
 
Joined: Jun 2004
Posts: 60
Likes: 0
From:
Default RE: General Muzzloader Questions - Newbie

i use a cva magbolt and i use pyrodex powder and powerbelt bullets and i swab the barrel bout every 5 times.
no u dont every time u take the breach plug out to clean it you should apply anti seaze grease to it. look on the tube im not completely sure butr dont over do it couse it could ooze into your barrel.
i use a very small fine pointed piece of emtal or a ice pic works good (dont ask how i found out) or small gauge wire but be sure not to scratch it. also a fine hard jet of air like out of a air tank will work good.
well it depends after bout 10 or 15 shots itll have a bad effect in accuracy but 5-10 nothing to worry bout.
well it sounds like you dont have the right tip on your ram rod the tip should be a dinted in circle to form to the top of the bullet. or your barrel is extremely fowled.
it is becouse your barrle is fowled with burnt powder.
use a ball starter i use a oak round handle ball starter with a brass shaft there only bout 10.00.
i use 225grn powerbelt bullets with 120grns of pyrodex powder and i get 1 to 2 inch groups at 50 to 100yds with a scope.but it all depends on how you shoot.
1shotkill is offline  
Reply