Homemade plow pics please
I have 4 sections from an old farm disc harrow. I would like to make a plow to pull behind my 4 wheeler or garden tractor - It is currently setup like this and is to large:
(((((( )))))) (((((( )))))) Can I use 2 sections like this: (((((( )))))) Or one section like this? )))))) or will it roll funny and want to pull to one side or the other? If anyone has some pictures of their setups I would like to see them please email to [email protected] or post here Thanks Mike |
RE: Homemade plow pics please
cdi3d
You can split it up - even into one section - but it might pull a bit off centered. If you think the 4 wheeler can pull it - ((((((( ))))))) is the better arrangement. Disks like this pull real hard on loose soil. It can/will ruin a transmission if you over-do it. |
RE: Homemade plow pics please
I am thinking of welding some 2" tube steel to allow for this config )))))) (((((( with a 8 deg turn on each set - Should pull a little easier and I can break it down to transport - Should be able to pull it - Most of the soil I am trying to break is old praire ground never broken -
Thanks for the reply - Anything else comes to mind let me know Mike |
RE: Homemade plow pics please
Have the front blades throwing out and the rear blades throwing in,How wide is it now while it is all sections together...
|
RE: Homemade plow pics please
about 7'6 wide - to wide to pull with my four wheeler and garden tractor - I was hopin for something smaller so I could transport it - and get to remote spots -
Thanks Mike |
All times are GMT -8. The time now is 12:40 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.