RE: atv plows
 

here is a pictore of the base

RE: atv plows
 

http://www.mountaineeroffroad.com/members/bobby/DSCF0001111.JPG

RE: atv plows
 

http://www.mountaineeroffroad.com/members/bobby/DSCF000211.JPG

RE: atv plows
 

the tongue between the base and where it will hook to the atv will be 36"


the base is 41" wide and weighs id say about 75lbs or so by itself

RE: atv plows
 

jeese with all that steele i would've thought it would weigh more than that. looks like it's coming along well.

RE: atv plows
 

it could be heavier....I was just guessing....... thats just the base/Ibeam.............. thte tongue will be made out of 1/4" thich 2"x2" square tube..... the the weight of the wheels and mounts.......... then a few pounds for the spikes/harrows......... when im done it will have a spot to add weight on top of it too

RE: atv plows
 

well....finished it up for now........... took it and tested it out

on soil that is already bare it does a great job in just a pass or two...

but for soil that is thick in weeds/grass its a good rake...haha

heres a few pics

RE: atv plows
 

RE: atv plows
 

http://www.mountaineeroffroad.com/members/bobby/DSCF0002111.JPG

RE: atv plows
 

it tows behind the 4wheeler pretty good.... never know its there until your on a side hill or a rutted out climb..... (it kinda slid over and got my hung on a tree yesterday.....lol

the spikes are cut out of 1/4 thick mild steel..... about 1 1/2" wide and 10" long total.. a point was cut in each one..... then after welding them in place they were heated and bent into a curved shape...

the plow is 41" wide the tounge/hitch is 36" long (plenty of room to add someting to hold more weight)

the legs for the wheels are 14" long total...... cut and attatched at approximately a 35* angle so it will pull over obstacles better

if i add anything to it it will be a few discs for ground penetration ...... thought about buying the cheap one from Northern tool and just chop it up and weld it to this set up