Whats my prob.??
#11
Nontypical Buck
Join Date: Sep 2004
Location: WV
Posts: 4,485
I hear ya skeeter. I can only go with what actually happened. I was very reluctant to blame the scope (and remove it). I thought perhaps I was going to have to get the barrel re-crowned (although it looked fine to me) or that perhaps it was just "shot-out" (although it hasn't had over 500 rounds put through it). I was in a slight panic. I should get the thing bedded but there has never been a real need for it. It's a model 7 6mm (one of the first ones to come out). Now there is a chance that one of the screws off the base was loose or something (as I didn't check them until after I'd removed the scope, of course), but that still is a scope/mounting problem. Either way, I figured I'd let leupold take a look at the scope and let me know what (if anything) they find...said it will only take about 10 days. the barrel does get hot fast and I thought that may be the culprit (although it hasn't been an issue in the past). Anyway, if it's not the scope, i wouldn't know how to explain its return to the status quo by switching them out. if possible, I'll let you know that leupy says.
#13
Typical Buck
Thread Starter
Join Date: Aug 2006
Location:
Posts: 888
I shot the gun again today to make sure my form and everything was on point. I shot the best I could. Before I shot the 7mm08 I shot my 243 and had a 1/2 inch group, so I am assuming my form with the 7mm08 should have been as good. I did however notice alot of powderized brass along the underside of the bolt and at the front of the bolt where the casing makes contact. I also visually checked my scope mounts and rings and everything seems to be tigh and in order. The only thing I didnt look at was the bedding. I am shooting the hornady superformance ammo and do you think maybe the extra horse power may cause this gun to do this? Ahhh ima try some power points or core lokts and see if it changes...
#16
Typical Buck
Thread Starter
Join Date: Aug 2006
Location:
Posts: 888
basically just a shim for the barrel lug? Would I have to do anything towards the receiver and trigger? or just shim under the barrel lug?