water keel to weighted keel.....
I know the basic answer....plug one end of the keel, fill with sand, plug the other. I've done it before, but the calk that I used to seal the ends didn't hold very well.
So my question is: what is the BEST way to seal off the ends? What is the best calk? Also, I have a few decoys that have cracks and need repair....what have you found to be the best "glue" to seal off these cracks? Thanks in advance......... |
We used a chunk of stainless rod and silicone. The stainless rod was handy but any old weight will work.
|
Throw them away and buy weighted keels.
|
How about expandable foam?
|
We have used Gorilla Glue over a piece of paper wadded up on one end till it set up. Flip over, fill with sand and a few pieces of wheel weights, then piece of paper and Gorilla glue over that. Rough up inside of keel with sandpaper first for guaranteed bond.
|
All times are GMT -8. The time now is 01:34 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.