Matching arrows to bow
 

Do you like to get a lighter shaft and slowly cut it down to the right spine, or do you like to get a shaft that is closest to your bow and changing tip weights. Ive always cut my shafts down so I could shot the tip I want. I have had others tell me its better the other way. What do you guys do.

Im a little to cheap to buy a bunch of shafts above and below to see which is best.

RE: Matching arrows to bow
 

I like to do what you do. That is adjusting the shaft length first. I points that I start with would be around 145 grains (around mid point of weights). That way in order to further finertune, I havesometing else to use.

RE: Matching arrows to bow
 

With wood arrows, my options are limited--I need a full length shaft due to my draw length.

I still prefer to get the right spine to begin with, so I don't have an excessive amount of arrow hanging past the bow.

Chad

RE: Matching arrows to bow
 

I do what LBR does with wood, But I cut mine to 30" which gives me a 29" BOP. it took me awhile to find what I need for a spine, even when changing bows, but now I have it, and the spine I shoot works with all my bows. For Carbon, I chose the model, in this case Heratige 150's and cut them down to the length I wanted them at. and since I wanted closeto 160 gransup front, that worked out real well.

All I got to say in what ever you choose, tune the set up, some will say bare shaft and some will not. I did bare shaft once and t didn't work for me. I shoot broadheads when I tune and every time I go shooting, after I get the field point arrows flying good, I then shoot a broadhead arrow to see if the set up is really tuned.

RE: Matching arrows to bow
 

I always bare shaft my trad gear and paper tune my compounds. ;)

RE: Matching arrows to bow
 

I'm like Chad, only worse, forced to play with different spined shafts and tip weights due to my ape-armed draw length. And I have to use really stiff, heavy shafts to get the right spine.

I've been thinking about buying a set of takedown recurve limbs and makingmyself anoverdraw riser with an extended gripto fit them on. Then I'd be able to cut shafts to length and it'd open up a whole new world of arrow shafts to play with. ;)

RE: Matching arrows to bow
 

I can relate, my draw is a little over 30".