Trophy Taker on a Patriot Dually
 

Anyone using this setup. I just aquired a Shakey Hunter for my birthday. I was getting ready to set it up and it appears the shakey launcher is too wide and will contact the riser, and not go all the way down. Right now I have it set up behind the shelf, like a overdraw. Will this work ok or does any one have some suggestions. Thanks Brian

RE: Trophy Taker on a Patriot Dually
 

akasharkey.. Sounds like you have the centershot set too close to the riser. Depending on what year your bow is.. the center of the arrow should be 13/16-7/8" away from the riser. Hope this helps.

RE: Trophy Taker on a Patriot Dually
 

Its a 2003. Ill check it in the Am its been a long day.Thanks for the reply. Ill post a picture in tomorrow.

RE: Trophy Taker on a Patriot Dually
 

akasharkey.. on my '03 Pat dually.. 13/16" had me shooting perfect bullet holes. Let us know how it works out.

RE: Trophy Taker on a Patriot Dually
 

Right now it is set a 3/4 inch and it appears the very far edge of the launcher hits the part of thr riser shelf where it curves, but it appears to be going all the way down. Does it look ok where it is or would you go move it forward? Im going outside to put some shots through the paper

RE: Trophy Taker on a Patriot Dually
 

That looks fine to me... it's OK if the launcher hits the shelf and not the internal stop.

RE: Trophy Taker on a Patriot Dually
 

Ken thanks for all help. Got it shooting great.

RE: Trophy Taker on a Patriot Dually
 

I have that exaxt setup with the 2003 patriot dually. It is a tack driving setup. My second day shooting the bow after getting it tuned I robin hooded an arrow, and then almost two others. I then went to shooting at different spots, by far the most accurate bow I have shot, Only issue is there is no 80% letoff module for the patriot.