cam & 1/2 performance marks
 

Hi, i just put new string and cables on my hoyt and the top cam the performance make is dead center and on the bottom can the cable is about 1/8 of and inch to the inside of the hole, which cable do i twist to get the botton cam to match the top one, thanks for ant help.

RE: cam & 1/2 performance marks
 

Twist the cable closest to the hole a few times. Repeat if necessary.

RE: cam & 1/2 performance marks
 

do not go by preformance marks on the cam to get it in time!

you must check the timing at full draw one cam will have a draw stop on the module and the other will have a flat spot on the module the cables need to be flat in line with the flat of the module if it is not all the way into the flat the cam is under rotated, if the harness rolls over the flat of the module it is over rotated.
if the cam is out of time you can put a litle extra pressure on the harnesses to see which harness you will need to twist up.

I will see if I can dig up some pics to help illustrate what I am talking about

RE: cam & 1/2 performance marks
 

here you go, this thread at archerytalk has some good photos.

Good luck.

http://www.archerytalk.com/vb/showth...ht=Hoyt+timing

RE: cam & 1/2 performance marks
 

thanks that is the pic I was looking for
the top 2 pictures shows a properly timed cam ans 1/2 system