HuntingNet.com Forums

HuntingNet.com Forums (https://www.huntingnet.com/forum/)
-   Technical (https://www.huntingnet.com/forum/technical-20/)
-   -   The switch to aluminum (https://www.huntingnet.com/forum/technical/67998-switch-aluminum.html)

Lady Arwen 08-03-2004 01:14 PM

The switch to aluminum
 
So far I have been extremely pleased. Paper tuned this weekend and sighted in yesterday and today. At 20 yds. they were so tight that I could have pulled them all out of the target with one hand(6 arrows). No major accomplishment, but the last time I shot my old arrows they were all over the place. I'm not getting my hopes too high, but it was a big confidence builder that I really needed. Tomorrow I'm going to try to sight in the 30 yard pin. I also found that the weight tolerances on the raw shafts as well as the inserts was extremely tight. Inserts were all exactly the same and the shafts only varied by a couple of grains at the most. After group tuning I plan to slap some Magnus stingers on and should be ready to get my deer! (I hope!)

legacy22 08-03-2004 06:48 PM

RE: The switch to aluminum
 
Sounds good to me. Good Luck!

kevmo 08-03-2004 07:31 PM

RE: The switch to aluminum
 
im very pleased bout that & good luck

KIDD642 08-03-2004 09:18 PM

RE: The switch to aluminum
 
Those magnus stingers are sweet braodheads, I shoot those out of my recurve, though I have not killed anything with the recurve yet I have shot it at my target. I cannot wait to have the guts to put down the compuond and tak the recurve out. good luck with your set-up.


All times are GMT -8. The time now is 06:56 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.