carbon arrows loose in quiver
I just switched from aluminum to carbon arows. The carbon arrows, with their smaller diameter, don't fit tight in the slots of my Qwikee quiver. Anybody out there have any ideas how to tighten things up? Moleskin? Is there anything else I can use or do I have to replace the quiver?
|
RE: carbon arrows loose in quiver
I had the same problem,so I just got some Plasti-Dip at Home Depot and using a small brush,"painted" the insides of my quiver.Worked like a charm!!..Bob
|
RE: carbon arrows loose in quiver
Check the web and mail order houses. I believe KwikeeKwiver, but could be wrong, makes a different bottom part of the quiver that can be changed out to "grip" the smaller carbon shafts properly.
|
RE: carbon arrows loose in quiver
|
RE: carbon arrows loose in quiver
I used to use a Qwickie and found that the easiest way to do it was to use some fleece and cut strips. Wrap one halfway around an arrow and push it into the slot. Wiggle it around a little to make sure it sticks good and you are good to go.
|
RE: carbon arrows loose in quiver
Thanks to all for your recommendations. I went to my local bow shop and they had the Qwikee carbon arrow holder (the rubber piece) in stock and it only cost $6.00. Took care of the problem. I appreciate all your input.:)
|
All times are GMT -8. The time now is 09:10 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.