D Loops
 

How many of you use a brass nock along with your D-Loop? I have been trying to just use the D-Loop and can't seem to set it up right for proper nock height. As it tightens it moves upward a little making my shots bit nock high when paper tuning. How much fps will I loose adding a nock to my string along with the D-Loop. Any suggestions on how to tie the D-Loop to the correct nock height to where it will stay??

RE: D Loops
 

Sounds like your loop is not tied right, If tied correctly then it should not move.

That said instead of a brass nock if you want put in a tied in nock above and below your arrow to stop the pinch.

RE: D Loops
 

Yep, and I just removed the brass nock from my string and tied one on. One brass nock-set was 4fps. From 282fps down to 278fps----consistently.

RE: D Loops
 

is their a special way to tie nocks on same loop string that I make the loop with ?

RE: D Loops
 

They say a picture is worth a thousand words.

In this case what are movies worth?

try THIS link and check out the videos at the bottom

Also note that if you have a poorly done center serving (not tight enough), even if the loop is tied properly it will "walk up" the string.

RE: D Loops
 

You should try the knot-less super loop.They are a bit of a bitch to put on,but once you have them set up right,,GREAT LOOP !!!!