unibushings
 

What do you guys and gals use to attach these , I would guess hot glue , but was woundering if epoxie would work just as well . They look pretty delicate , and I dont want to damage them with heat . Im putting them in some beman matrix 400 shafts so I can use g-nocks with them instead of the super nocks that come with them . The super nocks seem to lossen up after some shooting and putting a new tight fitting nocks tighten up my groups . I am assuming that 3-60 acc uni adapters will fit and will use g-nocks with tem to cure the problem .

RE: unibushings
 

I slap them in with goat tuff

RE: unibushings
 

I use epoxy,that way you can make sure your bushings are going in straight, by twisting them.
The reason why i don't use goat tuff or similar glues, is they set up too fast, before you can check to make sure they are straight.
Also the 3-60 bushings usually have some slop, they are not a super tight press fit.
I use a good grade alcohol, to clean the bushing and core before epoxying.

RE: unibushings
 

Thanks guys , I hope they fit my beman matrix shafts