HuntingNet.com Forums

HuntingNet.com Forums (https://www.huntingnet.com/forum/)
-   Technical (https://www.huntingnet.com/forum/technical-20/)
-   -   Nock Pinch problem (https://www.huntingnet.com/forum/technical/357684-nock-pinch-problem.html)

wvdeerhunter22 01-26-2012 03:48 AM

Nock Pinch problem
 
I recently switched to Carbon express maxima hunters from easton axis. The CX nocks fit much tighter on the string and the arrow lifts off the rest. Any suggestions for remedies? Also I am concerned about the tight fit on the string reducing arrow speed.

Any help would be appreciated.
Thanks
WV

HDMontana 01-26-2012 01:32 PM

Your serving is probably to thick for the new arrow nock. There are two easy fixes for this, one of which is to get different nocks. A lot of the popular carbon arrow brands can interchange nocks. most gold tip and some easton nocks will work. Currently I have been shooting the Bohning brand double lock nock. If you get these then make sure the nock is snapped completely on before shooting arrow. Almost a double click when nocking. The second way to fix problem would be to have the bow reserved with a thinner serving material. Older bows usually have a pretty thick serving on them. If your bow has the plastic type serving then I would for sure get it reserved with a new serving material. Also, a lot of the new nocks are smaller because the bows nowadays have the thinner serving on them so if you do have an older bow then reserving is probably the best option.

snake42 01-27-2012 12:03 AM


Originally Posted by wvdeerhunter22 (Post 3905176)
I recently switched to Carbon express maxima hunters from easton axis. The CX nocks fit much tighter on the string and the arrow lifts off the rest. Any suggestions for remedies? Also I am concerned about the tight fit on the string reducing arrow speed.

Any help would be appreciated.
Thanks
WV

I use a digital caliper to measure the serving diameter at the nocking point. Using that figure I use a drill bit a couple of thousants larger and drill out the base of the notch in each nock untill it free floats on the serving. I then use a swiss pattern needle file to open up the notch until I reach the proper tension for good arrow release. Once done it does not have to be done again unless you change nocks. Having the free float on the serving eliminates string torque on the arrow which can happen if you don't nock your arrows in line with the rest and the nock is too tight.
Hope this helps!

Snake42

wvdeerhunter22 01-27-2012 04:24 AM

I switched to bohning signature nocks and tied in a nockset. Problem seems to be solved. Thanks for the help.

HDMontana 01-27-2012 05:28 AM

Glad you found a solution. I think you will like those arrows. I switched from easton acc's to carbon express maximas 3 years ago and I really like them.


All times are GMT -8. The time now is 12:30 AM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.