[Deleted]
 

[Deleted by Admins]

RE: Cam play on my MQ32
 

Wear on your axils or roller bearings can cause that allso

RE: Cam play on my MQ32
 

I had the same problem on my mq1. The shop put a shim/washer on the axle and it took up the slack.

[Deleted]
 

[Deleted by Admins]

RE: Cam play on my MQ32
 

Bowscout the thing to do is to have someone who knows what they are doing take it apart and look at it , if your lucky its only the shimms or axils , they are cheep ' the roller bearing cost a littel more like $10 bucks apeice , and then you' ll get some shops that will say we have to replace the whole cam and ideler , thats probably what mathews mandates and they cost . hopefully shimms and axils will take care of your problem

RE: Cam play on my MQ32
 

Last time I checked, Mathews has a lifetime warranty on everything except strings and cables. Although I did get a free set of both directly from the manufacturer.:D Take it in to your Mathews dealer.[:-]

RE: Cam play on my MQ32
 

I have owned several mathews bows, including the mq-32, and iam yet to see one that did not have some play in the cam.
You can take it to your dealer, and he can replace the bushings, but be prepared to replace them again.

RE: Cam play on my MQ32
 

Hey wait a minute, I had to pay for my new bushings when my old ones wore out[:@]!!

RE: Cam play on my MQ32
 

I had to pay for them too. I was told that it is a normal wear item. It was only $6, so no BFD.
Charlie

[Deleted]
 

[Deleted by Admins]