Kisser button install
 

do I have to have the string removed to do this,want one more anchor point on the compound for reassurance.Or can I just get something served in and be secire enough?

Kisser buttons snap onto your string.... don't need to press it at all. You can then tie it in, or you can use the crimps that are usually provided with the button itself.

No need to remove the string But I would recomend if you dont have the tools to do so take it in. Only takes a minute. If you have the tools then you may want want another person with you so that person can slide the kisser into the right position while youre at draw. Please do not let go of the string at that time!! Once its in the correct spot, lower your draw and crimp the kisser to the string.

Thankyou gentlemen!

no u dont hae to take the string off, if u did that would really suck

There you go Rowel, calling people names again.

I was going to ask this same question But Thanks to this thread I don't need to and i got the answer i was looking for in some form .

But if anyone can Please go into more detail about how to set the kisser button ? It would be extremly helpful . . .

Thanks in advanced.