|
RE: Issue with my Limb Driver
A friend of mine had the exact same issue as you.He took it by the tru ball booth at one of the ASA shoots and with 1 glance,the person said it was adjusted wrong.He adjusted the top screw back in and readjusted the screw on the back and then reset the top screw and it was fine.Took him about 2 minutes.
|
RE: Issue with my Limb Driver
ORIGINAL: TFOX A friend of mine had the exact same issue as you.He took it by the tru ball booth at one of the ASA shoots and with 1 glance,the person said it was adjusted wrong.He adjusted the top screw back in and readjusted the screw on the back and then reset the top screw and it was fine.Took him about 2 minutes. |
RE: Issue with my Limb Driver
ORIGINAL: drockw ORIGINAL: TFOX A friend of mine had the exact same issue as you.He took it by the tru ball booth at one of the ASA shoots and with 1 glance,the person said it was adjusted wrong.He adjusted the top screw back in and readjusted the screw on the back and then reset the top screw and it was fine.Took him about 2 minutes. Many people adjust the top screw when the back screw is not adjusted properly,putting it out of sinc.It didn't back out on him,he just adjusted it wrong. |
RE: Issue with my Limb Driver
ORIGINAL: Cougar Mag Solution: L O C T I T E Dan |
RE: Issue with my Limb Driver
ORIGINAL: MeanV2 ORIGINAL: Cougar Mag Solution: L O C T I T E Dan Can cause a few as well.:D Don't let it touch some plastics.Also,don't use red.[8D] |
RE: Issue with my Limb Driver
I didn't know there was anybody in the Archery world that ever used Red.
I used to Loctite everything on my Bow back in the Hatchet Cam days. I don't any more and hardly ever have any problem with anything loosening up, but if I do the little blue tube is always close by.;) Dan |
| All times are GMT -8. The time now is 06:54 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.