|
Broadhead tuning help needed!
OK, I have my Hoyt Vectrix XL shooting good through paper with field points. A guy at work gave me a slick trick magnum to try out. I shot it and it shoots a few inches high and to the right of where my field points hit. This was at 20 yards. Should I move my sight or my rest and nock point to bring in the slick tricks to hit where my field points do? I have read so much about how slick tricks shoot like field points, in my case they do not. Any help would be great.
Background info. I shoot 70lbs, 29"dl, TT shakey drop away, beman 400's, 100g tips I have been using NAP spitfires for over three years now and love them they work great for me and they fly just like my field tips. I was just wanting to try somthing new. |
RE: Broadhead tuning help needed!
Well,at 29" draw length and shooting a .400 spine arrow at 70#'s,I am going to say the broadhead hitting right is due to the arrow spine being too weak.As far as too high,I would say the rest needs to be moved down slightly as well.
I would try to tune by moving the rest towards your field points but I doubt you will have much succes with that arrow spine. |
RE: Broadhead tuning help needed!
As soon as I saw the arrow spine - I had the same thought as T-FOX- underspined. You should seriously consider bumping up to a .340-ish class spine- the fixed blades AND your Spitfires will be better off.
|
RE: Broadhead tuning help needed!
ORIGINAL: TFOX Well,at 29" draw length and shooting a .400 spine arrow at 70#'s,I am going to say the broadhead hitting right is due to the arrow spine being too weak.As far as too high,I would say the rest needs to be moved down slightly as well. I would try to tune by moving the rest towards your field points but I doubt you will have much succes with that arrow spine. |
RE: Broadhead tuning help needed!
Definately the arrow causing some of that. 400 spine would be good for about 63#'s or so im guessing. Anyone with AA wanna do it?
Derek |
RE: Broadhead tuning help needed!
Do you think I could get away with a .360 spine? I got on the Beman web site and for my arrow length and draw weight they suggest the ICS Energy 360's.
|
RE: Broadhead tuning help needed!
Your arrow spine as TFOX and Jeff mentioned will caused your arrow to fly to the right (assuming) your releaseon your right hand. Underspined. 70# 29" DL, you'll need a stiffer shaft.However check to see is your broadhead sits flat on the insertand there's now 'wobble' if you spin test the arrow. Sometimes you have to switch the blades around and evenswap the washer.You also mentioned you got this broadhead from a buddy of yours, if it has been used it could have been damaged. Check the blades for any dings etc. A 70# bow will generate a fair bit of speed and a broadhead that isn't properly aligned will nail you tothe cross, most times.
|
RE: Broadhead tuning help needed!
ORIGINAL: WV Hunter ORIGINAL: TFOX Well,at 29" draw length and shooting a .400 spine arrow at 70#'s,I am going to say the broadhead hitting right is due to the arrow spine being too weak.As far as too high,I would say the rest needs to be moved down slightly as well. I would try to tune by moving the rest towards your field points but I doubt you will have much succes with that arrow spine. As for the arrows hitting high? You bet. Move the rest down or nocking point up. Shooting through paper shows you how the arrow is leaving the bow. Thgere are more factors than this that determine how it hits down range. Rear drag and FOC enter into it as well, and these do not show at a couple feet through paper. 20 yards is a lot longer than a couple feet so any imperfections will be readily seen, especially when you put blades up front. TFOX is right. Try to lower your poundage down to 60 and see how it flies before you attempt adjust anything, youneed 340's imo |
| All times are GMT -8. The time now is 05:13 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.