Arrow Selection software
02-02-2009, 02:54 PM
#11
Giant Nontypical
Join Date: Feb 2003
Location: HENDERSON KY USA
Posts: 6,634
RE: Arrow Selection software
I have found AA to be spot on with speed with draw specific cams or cams that are set at optimal but when dealing with module systems or rotating module cams like the admiral,I have seen the speeds off at lower draw lengths.So imo,you need to get an actuall speed before making a final determination.
After calibrating AA to actual speeds,I have found the spine selection to be perfect.
After calibrating AA to actual speeds,I have found the spine selection to be perfect.
02-02-2009, 09:17 PM
#13
Fork Horn
Join Date: Mar 2008
Location: New Zealand (Wellington)
Posts: 233
RE: Arrow Selection software
ORIGINAL: archer 2
Dogboy, I got the same results when I ran your setup through OT2. Even cutting the arrows down to 28.5 inches they showed in the bottom of the green zone.
Dogboy, I got the same results when I ran your setup through OT2. Even cutting the arrows down to 28.5 inches they showed in the bottom of the green zone.
So any ideas on what would be a good arrow set up?
I am open to suggestions?
