RazorTec Tuning
 

Anybody else having trouble tuning their RazorTec? My buddy came over with his new RazorTec tonight to paper tune it, and the only way I could get it to punch a decent hole was to set the nock way low that the front of the arrow was going up hill. Quite a bit I might say. I know that cannot be right because it is very noticeable by eye. Anyone else have any trouble like this with their new Hoyt' s? [:@]

RE: RazorTec Tuning
 

The only trouble I had was moving the cable from my drop away rest to avoid fletching contact. After that, I got a perfect bullet hole tear in the paper.

RE: RazorTec Tuning
 

You need to make sure the cams are turning over at the same time just like a 2 cam bow . If one cam hits its stop before the other then you need to twist the cabel accordingly . otherwise you will have the problem you are talkimg about

RE: RazorTec Tuning
 

I have just read about this same thing on another forum. Seems a few guy' s were having the same problem, and twisted up the cables to sync. the cams just like a twin cam, and this cured the problem. Thanks for the input.