2003 Hoyt Razortec tightening down question
I was out shooting last night and noticed that there was a slight rattle. So I started tapping it to figure out where it was coming from. I noticed there were some screws a little loose. So I torqued them down good. Are there any screws that I should not torque down real good? Are there some that should be a little loose?
Just don't wanna break it. The next time I draw it. |
RE: 2003 Hoyt Razortec tightening down question
Nothing should be loose, but don't over-tighten anything either. You don't want to accidently round off any allen bolts.
|
RE: 2003 Hoyt Razortec tightening down question
OK thanks. I've learned my lesson about tightening things too much. I just wanted to make sure there wasn't supposed to be some give in something. I don't know. I've been shooting for a little while but always contracted out my bow work. The rattle got my attention and I didn't want to have the thing blow up in my face. [&:]
|
All times are GMT -8. The time now is 03:10 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.