which launcher for the QAD ultra rest
#11

Blazers will hit the top bar with either launcher. I didn't think that they hit but I lost 15 fps with blazers, sure enough they hit. Just place an arrow on the restbackwards with the vane directly under the crossbar, hold the rest in the full upright position and line the shaft up with the nock. With Blazers being so common you would think that they would build in another 1/8" of clearance.
#12
Typical Buck
Thread Starter
Join Date: May 2007
Location: Belgium
Posts: 996

Centaur, that's how I checked and with the normal launcher I don't have contact on my blazers.
My new problem right now is that on the 82nd the rest can't be set high enough so that the launcher doesn't pop against the shelf of the riser.....
I mailed QADinc and they'll try to fix this...............
F.
My new problem right now is that on the 82nd the rest can't be set high enough so that the launcher doesn't pop against the shelf of the riser.....
I mailed QADinc and they'll try to fix this...............
F.
#13

I have this rest on all my bows, shoot 2" Blazers, and have the bar in place. I did, however, grind about 1/3 of the bottom of the bar away with a belt sander. Shoots great - no clearance issues - Hoyt bows.
#15

I use the Qad with blazers.. I was hitting the top bar with my mathews bow. I just took the bar off and all seems well..
Taking the bar off doesn't have to be done by cutting, putting in a press or even with a punch.. Just grab it with your fingers and wiggle it back and forth.. It's comes right off, well the several that I've messed with have anyway..
I've never even tried the Tl1 launcher, my bow is a solo cam..
Taking the bar off doesn't have to be done by cutting, putting in a press or even with a punch.. Just grab it with your fingers and wiggle it back and forth.. It's comes right off, well the several that I've messed with have anyway..
I've never even tried the Tl1 launcher, my bow is a solo cam..
Thread
Thread Starter
Forum
Replies
Last Post
Tosoro Hunter
Technical
4
02-22-2004 08:15 PM