HuntingNet.com Forums - Axis Inserts With Epoxy--Removal?

Page 2 of 2

Show 40 post(s) from this thread on one page

HuntingNet.com Forums (https://www.huntingnet.com/forum/)

- Technical (https://www.huntingnet.com/forum/technical-20/)

- - Axis Inserts With Epoxy--Removal? (https://www.huntingnet.com/forum/technical/242035-axis-inserts-epoxy-removal.html)

deroche117

04-13-2008 01:22 PM

RE: Axis Inserts With Epoxy--Removal?

I don't think the ends of the arrow were cut incorrectly as I used the same Apple saw to cut each. Also, the tips of the hidden inserts are actually completely inside the shaft. I will take your advice and re-inspect them though just to make sure. I'll try anything at this point. ~J~

brucelanthier

04-13-2008 02:16 PM

RE: Axis Inserts With Epoxy--Removal?

Quote:

ORIGINAL: deroche117

I don't think the ends of the arrow were cut incorrectly as I used the same Apple saw to cut each. Also, the tips of the hidden inserts are actually completely inside the shaft. I will take your advice and re-inspect them though just to make sure. I'll try anything at this point. ~J~

I cut my shafts in an Apple saw too but it is always a good idea to square of the cut end. I also square off the inserts once they are in and the glue is set. A good tool for this is the G5 A.S.D. (arrow squaring device).

MeanV2

04-13-2008 04:35 PM

RE: Axis Inserts With Epoxy--Removal?

LT,
If you end up needing or wanting new HIT inserts shoot me an address in a PM and I'll send you what you need, N/C

Dan

All times are GMT -8. The time now is 01:23 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page