|
Why?
Cut part of your arrow from the nock end? I have seen a few people say this and I was wondering why?
|
RE: Why?
The endsare where you get most of your inconsistancies in a shaft. Arrow straightness is measured over a 28" span. Guess where they measure that 28 inches? in the middle of the shaft.
|
RE: Why?
It also can make it easier to make a spine adjustment on a carbon arrow since you don't have to worry about the insert.
|
RE: Why?
Rifle barrels are that way too. A new barrel blank needs to have at least 1" cut off of each end to get rid of run out that occurs in the manufacturing process.
|
| All times are GMT -8. The time now is 12:02 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.