Am i overspined or am i ok?
My seput is a101st at 60lbs and a 29"dl with a 100 grain tip. I got some 340's easton epics the other day so am i overspined? I think the chart says 400's but i guess i looked at itwrong. They seem to be shooting ok tho. So thanks for any help.
|
RE: Am i overspined or am i ok?
Whats the arrow lenght, fletch and nock?
|
RE: Am i overspined or am i ok?
I'd say you could shoot the 400's, but if the 340's are shooting fine and you have them. Just Git-R-Done!!
Dan |
RE: Am i overspined or am i ok?
ORIGINAL: Ausie-guy Whats the arrow lenght, fletch and nock? |
RE: Am i overspined or am i ok?
AA does not list the 101 so I used the 82nd.
Ran your numbers and it say's you are slightly weak. I will pm the snap shot of the chart it is too big to upload here. |
RE: Am i overspined or am i ok?
ORIGINAL: MOhunter46 ORIGINAL: Ausie-guy Whats the arrow lenght, fletch and nock? Dan |
RE: Am i overspined or am i ok?
Well, only one way to tell. Knock off those vanes off one or two. Go out at 30 yards, and shoot the bare and the fleteched, and see where they hit.
|
RE: Am i overspined or am i ok?
I would suspect you are overspined with the 340's. Try a bare shaft - see ifit hits the target angle left.
|
RE: Am i overspined or am i ok?
ORIGINAL: MeanV2 ORIGINAL: MOhunter46 ORIGINAL: Ausie-guy Whats the arrow lenght, fletch and nock? Dan |
RE: Am i overspined or am i ok?
Sent you another PM
You can cut the shaft from the back but you will have to re-fletch them. |
All times are GMT -8. The time now is 03:57 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.