RE: would this work?
 

this is how i did it..

RE: would this work?
 

Brandon,

You are doing that right. As far as your bow's DL. What was your bow set up for? What does the sticker say on the lower limb? There is a big difference in 1" of DL and definitely will affect spine.

You sure what you were using wasn't for arrow length selection and not DL? If has a rest on it with markings and you draw it back and look at where the mark is in relation to the rest it's for arrow length, not DL.I have a 30" DL and can shoot a 27" arrow based on rest position.

Make sure you select Hunting and not Target in the Spine Sizing tab. Eitherway, you could still can use the 29" arrow and if your DL is 28" it would work even better.

RE: would this work?
 

I suppose another question is..."How tall are you???" Or have you tried the "wingspan" method for drawlength??

Dave, how do you get the page to copy and show up like that. I just bought OT2, but can't figure out how to cut-paste with it.

RE: would this work?
 

That's a good question OH about his DL. From the picture I'd bet that bow is 28" and not 27".

You have to do a print screen command. "CTRL+ print Screen" and then past that into the picture softare you have. Then crop the picture accordingly. To post it you will have to compress the image and such.

RE: would this work?
 

Thanks Dave!!

RE: would this work?
 

THE CAM SAYS "RSH4" AND THATS IT...

IM JUST ABOUT 5'9

I HOPE IT DOESSPINE BETTER...

RE: would this work?
 

come on guys i need to get some arrows and i need yalls help....im headin to basspro on monday...

on the 4560's

it seems to be spined pretty good at with a30inch arrow

RE: would this work?
 

4560's
Your call on arrow length. You have to shoot an arrow length that you are most comfortable with. The 30" arrow is definitely ok.

RE: would this work?
 

i think this setup would work...right?

RE: would this work?
 

So, you've figured out the DL is 28.25". That will definitely work.