little help please
 

need some calculation on my arrows and set up
bowtech general 55 lb -27inc draw peep with tube ,kisser button
cx aramids with 125 montechs with blazer vanes cut at 26 1/2 inches
and acc 3-49 cut at 25 inches with stiker 100
thank you guys

ps i cant belive im finally able to log in after 1 1/2 years of waitng and checking out this great forum

RE: little help please
 

What exact kind of info are you looking for?:D

Dan

RE: little help please
 

ke ,speed ,and foc
thanks

RE: little help please
 

Well the IBO of the General at 70# 30" drawis 300-308 fps with Smooth mods and 307-315 with Speed Mods. Obviously you are going to shoot 15# and 3" draw length below that. Draw alone will cost you approx. 30 fps. The Tube on the peep will cost you another 10 to 15 fps. 15# draw weight will cost you approx another 30 to 35 fps. Then if your arrows are lighter or heavier than 350 grains you will have to make some adjustments there. What spine Aramids are you shooting? The 3-49's would seem stiff to me at 25" for 55#. Here is a KE calculator if you can obtain the correct info;)

http://www.bowhuntinginfo.com/KineticEnergyNew.htm

Dan

RE: little help please
 

armid 250
27 inch drawwith speed mods

RE: little help please
 

i dont have a chrony so im not sure fps to use that cal ,just wondering if anyone could maybe run it on ontarget
thanks