Axles......please help
 

Well..I dry fired my bow..Beginner Mistake....The Cable broke. I had a guy make me new strings and cables.Well he thinks I might have bent my axles. I'm shooting OK groups from 15-50yds.

If it has a bent axle...how much will it cost to get it fixed?????

RE: Axles......please help
 

Axles are easy to change out and easy to see if they are bent. I use a 3/16" pin punch. I press the bow, and push them out. I then put them in a drill press, and spin them to see if they are bent.

It should cost more than 30-40 dollars to change out.

RE: Axles......please help
 

They're a few bucks tobuy some new ones... Probably wouldn't be a bad idea just to change them out anyway.

RE: Axles......please help
 

I suggest changing them when a bow has been dry fired because they are relatively inexpensive and without the PROPER tools,very hard to check to see if they are actually straight.

I can check them because I have the proper tools,due to the factI am a tool maker by trade.


A SMALL bend in an axle can cause problems that you may not even pick up on.The axle can actually spin,especially when bent because the cam will catch the high spot and roll the axle a little.With the axle being bent,you will have a different rollover with each shot and from time to time,you will get on the bend and have a high or low arrow.

I prefer to eliminate the doubt by replacing them.

RE: Axles......please help
 

TFox, whats a good way to check except throwing it in a straight drill press? I have some granite machinist tables that are straight within a .001". Is rolling best?

RE: Axles......please help
 

Thanks guys

RE: Axles......please help
 

What else should I replace??

Also its making a Squeking noise when I release the bow.
Its not the cable slide,must be around the cam area!