Allegiance vane clearance
I have a 06 Allegiance and am using Blazers,I was wondering if anyone had clearance issues with these vanes.Thanks
|
RE: Allegiance vane clearance
On my OG, the blazers needed to be shot with cock vane shot slighty turned in toward the cable (if shooting cock-up). With the cables being so close to the string, there isn't a whole lot of room for a high profile vane, but by tipping it slightly, they worked fine.
|
RE: Allegiance vane clearance
I had the same issue Mike did, and fixed it the same way. I also replaced the cable slide with a Sims teflon. It is lower profile than the stock slide and that also helped.
|
RE: Allegiance vane clearance
It must be a Bowtech thing. My Black Ice hastight clearence also. I have to turn the vanes some to get by the cables. I'm giong to get a different slide.
|
RE: Allegiance vane clearance
I was having clearance issues with my tribute soI replaced the blazers with flex fletch vanes and all is good.
|
RE: Allegiance vane clearance
I don't think you'd loose much "stearage" if you cut the Blazers down 1/8 of an inch;)
|
RE: Allegiance vane clearance
I had an 05 allegiance, same problems with clearance. I was shooting quick spin 2 inch speed hunters, they have the same outline as a blazer. Just a slight turn in took care of it or switch to a slightly lower profile vane.
|
All times are GMT -8. The time now is 02:19 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.