thoughts/opinions/help
 

Ok, I'm in quite a quandry, and I've got a couple different problems that have been on my mind concerning my bow.

1) I shoot PSE Radial X-Weave 300's and PSE Dominator 300's. X-Weave weight is 8.6 gpi, Dominators weight = 7.8. At twenty yards, I can robin hood one with the other so they shoot the same there, but what difference will the weight differential make at 30, 40, or even 50 yards? I tried out the x-weaves and bought a dozen of them when my arrow supply was low, and only have a few dominators (about 7), and I'm only going to buy one or the other exclusively for now on. That's why I have a mix and match of them now.

2) I use a 3 pin copper john dead nuts sight (going to buy 3 more pins for it soon), and I have a slide-sight as well (it may be called something else, but it's one pin that you have a slide bar adjuster for...). Considering there are two holes that mount the sight bracket to my bow, and if I sighted in both sights on my bow, shouldn't either one be dead on when I re-mount it? Maybe a little fine tuning sliding the sight rack, but I would think they would be right on, because there are only two holes the screws can go into.

Thanks for the read and your .02

RE: thoughts/opinions/help
 

ive always found them to go back in the right place when remounting the sights... always shoot good anyway

RE: thoughts/opinions/help
 

I wouldn't necessarily count on the sites being dead on when you put them back on. I'd shoot it to make sure.