cjclemens

I use the Lyman treated corn cob media. I haven't noticed any issues with dust, but I usually run the polisher with the lid closed, unless I'm picking the finished cases out of it. Right or wrong I also polish brass with the spent primer still in them. It usually keeps media from getting stuck in the flash hole.

SecondChance

I use walnut hulls myself for rather cleaner brass and corn cob for the really dirty then finish up with walnut hull. I get my walnut hull stuff at the pet store and it is for lizard cages. Cheaper than the Lyman stuff and I add just some car polish my brother gave me, no ammonia, like others have said. Bad juju for the brass.

I also don't like the rice. Didn't work as good as the others. And then I tried to re-use instead of just throwing it out. Even with hot sauce, it didn't make the pollo loco taste worth a darn!!!!!!

sdeviation

i used to put an old sock in there to help suck up the red stuff,,,
then i went ultra sonic...9 worked real well if u kept up the cleaning after every firing...
now i use stainless steel pins... which seems to do the best job
in cleaning...

Ridge Runner

wonder how steel shot would work?
RR

Sheridan

Just like burnishing beads I would guess ?

http://www.thomasnet.com/profile/005...203&cid=573756


RR - simple is always the best way !

sdeviation

u could pic up a casing thats bin in the ground for a few years
put it in the stainless pin wash and u would think it just came out of the bag ...lol.
i think the pins are like 1mmx5mm long
so they can get into the primer pockets a lilttle...
back to the original poster ?...
i heard sum buying crushed walnut from pet shops for lizard cages
it doesnt have the rouge ( polish compound ) in it, if that helps...
i also have 2 vibratory tumblers and when i used to use them i used lymans walnut in one and lymans green corn cob in other.... the corn cob takes longer ....

Mr. Slim

i dont tumble my brass with the primers pushed out. i leave the fired ones in so the media wont get stuck in the primer space or flash hole. i clean the primer pockets out after tumbling with a primer pocket brush and the flash hole a reamer made for that job. i also use a clean bore brush to clean the inside of the necks to remove any powder residue. then im all set to reload.

SecondChance

Doesn't it get stuck just the same, though maybe not as much, when it enters the case from the mouth and into the flash hole as opposed to entering from the primer end? I would think that this would lead to damaged depriming pins and expander rods with it not having anywhere to go when being deprimed and resized.

bronko22000

I use crushed walnut shells and I deprime first. I inspect each case after cleaning anyway and remove any media in the flash hole. I made a tool for that. I took a screwdriver and ground both edges to form a point in the middle small enough to fit the flash hole and ground the remainder of the head so it will fit into the primer pocket. This way I can clean the primer pocket and clear the flash hole at the same time.
But this is the first time I heard of putting some patches in the media. I'm going to have to try that trick.

Dmitry75

Best of all, ultrasonic with citric acid and a little dishwashing detergent.