HuntingNet.com Forums

HuntingNet.com Forums (https://www.huntingnet.com/forum/)
-   Reloading (https://www.huntingnet.com/forum/reloading-15/)
-   -   Whitetail load (https://www.huntingnet.com/forum/reloading/271067-whitetail-load.html)

T.Gsportsman 10-31-2008 07:48 PM

Whitetail load
 
This is for all you reloader's out there
I am shooting a 7mm-08 for the first time and I am hand loading it. I am shooting 150 gr ballistic silvertips.
I finally found a load that grouped well with my rifle but i am only shooting 39gr of vihtovouri n150 powder. My concern is that this is a slow burning powder and I am just not sure it will have enough umphh for whitetails my shots will NEVER be over two hundred and likely 100 and probably most 75- 50 yds. The season is two weeks away and i have already loaded my hunting rounds. Is it going to give me enough energy with this particular load? I am guessing its leaving the barrel at 2400 fps. I taped some old glossy catalogs together 4.5 inches thick with a complete pass through at 100yds with good expansion. This is a quick expanding bullet that fragments easy as you may know so i don't think expansion will be the trouble. I am mildy concerned over the penetration though. Thoughts?

thanks trevor

goatbrother 10-31-2008 09:29 PM

RE: Whitetail load
 
You'll be fine, bet that is a nice load to shoot. Looking at the loading manual your load approximates top loads of the 7x30 Waters. Better than a 30-30 so yes, you will kill a deer just fine.

T.Gsportsman 11-01-2008 05:06 AM

RE: Whitetail load
 
Thanks for the reply. Yes it is a nice load, low recoil and it prints 3/4-1/2 inches at 100 so very good for a light barreld hunting rifle


bronko22000 11-07-2008 06:51 AM

RE: Whitetail load
 
Yes - I'm sure no deer would know the difference between your load and another at maximum. Some rilfes and/or chamberings are more accurate with sub-maximum loads. Others prefer to be pushed hot. Rifles are a lot like women - you have to see what suits them best. (Some can be pretty fickle and others don't care)


All times are GMT -8. The time now is 03:37 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.