loading for 30-06
 

Fairly new to reloading, started this spring and have probaly shot over 200 rounds thru 2 different 06's. Started with IMR4350 nothing impressive. Been having a lot better results with 48.7 grains of IMR4064.
Anyone have a pet load with any different powders???

RE: loading for 30-06
 

I shoot 165 Nosler Ballistic tips with 58 grains of H4831 with Federal 215 primers in Remington Brass.
Sub MOA.

I have used IMR4064 with 150 Speers and Federal 210's with good luck as well.

Usually IMR4350 works very well with 165's.

T

RE: loading for 30-06
 

hornady 165 grain SP IMR 3031 44.5 grains
hornady 165 grain SP imr 4350 50.0 grains
both C.O.A.L.of the top of my head 3.300
http://i15.photobucket.com/albums/a380/lonewolf5347/30-06target001.jpg
I shoot off the lands so I always use the bottom of the chart FPS

RE: loading for 30-06
 

Here's my favorite deer load:

165 gr. Hornady Interbond
57grs. H4350
Fed210M
Lapua brass

RE: loading for 30-06
 

Too bad you can't get H0205 any longer!!

DM

RE: loading for 30-06
 

I have a favorite 51 gr 4320 and a 150 gr hornady or remington Put down lots of deer good groups in my Ruger.

RE: loading for 30-06
 

I have 2 main loads for my 30-06
150gr Horandy IB with 60gr of H414
165gr Sierra Gameking with 57gr of H414

I have have some 150 gr barnes with 61grs of H414 loaded in the past

all bullets are moly coated

I really like the IB load its accurate and works great on deer, closest deer was 20yrds and furthest was 280 with this load....neither went any more than 50 ft

RE: loading for 30-06
 

This is my load for my 06 56grs IMR4350 with 165gr nosler bt or sierra gameking hollow point boatails. Fantastic groups with this load out of my rem 700 and ruger m77.

RE: loading for 30-06
 

There are more different loads for the .30/'06 than the number of dollars Bush is asking for in the big bank bailout! The problem with "pet loads" is that a pet load is merely a pet load for the gun in which it was developed!

However, there are some powders that usually do well in certain rounds. And for the old '06, IMR 4064 is certainly one of these. A very good accuracy load for the M1 Garand has always been 47 grains of IMR 4064 and the Sierra 168-grain Match King bullet.

These powders are alsogood: RL 15,RL 19, IMR 4895,H414, WW 760, and IMR 4350 too, if you get the right amount. In addition, the new Alliant RL 17 looks promising in rounds having bore capacities in the same range as the '06.......

Good luck!

RE: loading for 30-06
 

NICE!!


I just moved back to my old house in upstate NY from having lived is PA since 2000. Imagine my surprise when I discovered half a pound of H205 here. I used to use55.7 grains of thispowder with a 200-grain Nosler partition in my J. P. Sauer 8X60RS double rifle for a MV of 2620 FPS. This load shoots into 2.6" at 100 meters fromboth barrels.

While in PA, I worked up an accurate, regulating load with the same bullet, using 59 grains of RL22. But the MV was only 2450. I hope this H205 powder is still good! It looks OK, but powders do lose strength from absorbing moisture over the years. And this is a real HUMID place!

I'll try it, however!

Here's a target with the 59 grain, RL 22 load fired at 100 meters, using both barrels.