HuntingNet.com Forums - Priming Shotgun hulls?

Page 2 of 2

Show 40 post(s) from this thread on one page

HuntingNet.com Forums (https://www.huntingnet.com/forum/)

- Reloading (https://www.huntingnet.com/forum/reloading-15/)

- - Priming Shotgun hulls? (https://www.huntingnet.com/forum/reloading/233603-priming-shotgun-hulls.html)

doubleA

02-23-2008 07:49 PM

RE: Priming Shotgun hulls?

So Johnny, it sounds like you are turning yourshells out of brass stock which I can understand doing to get the sastisfaction of making them yourself but I would certainly look at the Magtech brass shot shells that are available. I am sure trimming them to your length would'nt be a problem. They use a large pistol primer.

flutedchamber

02-24-2008 07:25 AM

RE: Priming Shotgun hulls?

Quote:

ORIGINAL: johnny2

Forgot to mention,I make my own shells..Takes time and a big waste
of brass..I have only 8 made up so far..Some times I just use the
federal plastic hulls cut to fit.My chamber is only 2 5/8 inch

Well, that may be why they use 209's when anything else uses rifle/pistol primers...

johnny2

02-24-2008 05:08 PM

RE: Priming Shotgun hulls?

Double A I check ed the site but did not see any 10gauge brass??

doubleA

02-24-2008 07:05 PM

RE: Priming Shotgun hulls?

Johnny2
My appologies,I was refering to 12 ga brass. I missed the 10 ga in your post.

All times are GMT -8. The time now is 05:29 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page