? about preping brass
After I trim My brass. I debur the outside of the case than use that tool to put the bevel cut on the inside so the bullet will seat in the brass smothly... What I was wondering... Do you put the bevel cut in the brass every time you load it... Or is once good as long as you dont trim your brass??? [/align] |
RE: ? about preping brass
You only need to do it when you trim the cases.
|
RE: ? about preping brass
ORIGINAL: Mr. Longbeard After I trim My brass. I debur the outside of the case than use that tool to put the bevel cut on the inside so the bullet will seat in the brass smothly... What I was wondering... Do you put the bevel cut in the brass every time you load it... Or is once good as long as you dont trim your brass??? |
RE: ? about preping brass
Without trimming, unless a visual inspectionsuggests otherwise, you shouldn't have to deburr/chamfer. The cutting blade on the trimmeris what makes the damaging burrs, so you should be fine without. Remember, you still need to check each case to make sure there isn't any obvious brass burrs sticking out, then you're good to go.
|
RE: ? about preping brass
Just be sure any chamfering you do is minimal. You don't want to be putting knife edges on your brass, simply removing any burrs from trimming. A little chamfer on the inside of the case moth, when done evenly, will aid in straighter bullet seating, like bigcountry said.
|
RE: ? about preping brass
Thanks
|
RE: ? about preping brass
Ditto what they said:)
|
All times are GMT -8. The time now is 03:11 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.