Case champfer
So how much do you actually champfer? Got some brass from a guy and he resized and primed, I can't beleive how much some people champfer their cases, you could shave with that lip it's so sharp..
|
RE: Case champfer
I do as little as possible. So if I am shaving copper, I do more. With the wilson attachment I have, I put on a drill and do it. I rember when it was new I could cut alot but now it doesn't take off too much.
|
RE: Case champfer
I will just remove the square/sharp edge off of new brass or ones I have trimmed with a de-burring tool.
It might be me.... but I dont take any brass from anyone unless it's once fired from the factory, it's just a saftey thing with me. |
RE: Case champfer
CrimeDog:
I use a RCBS Trim Mate Case Prep Center. I set the trimmed case on the Inside Chamfering & Outside Deburring Tool for about 1.5 seconds each. Good luck. |
All times are GMT -8. The time now is 12:25 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.