What dies do I need?
 

I am just getting ready to buy my first set of dies for th new 25-06 I got and I seeing 2 die sets 3 die sets...I am looking at getting the Lee's because that is waht my press is...but what is better for reloading the 2 die set? the 3 die set? what is the difference??

RE: What dies do I need?
 

I recommend the three die set. You will also need a shell holder.

RE: What dies do I need?
 

Get the lee collet die set and the factory crip die.

RE: What dies do I need?
 

Get the 3 die collet set.

RE: What dies do I need?
 

in cabelas they call is the Pacesetter set...is this the correct one??

RE: What dies do I need?
 

Lee delux rifle die set.

-shellholder
-collet neck sizer
-Full length sizer
-bulet seating die
+ other accessories.

I wouldn't bother worrying about a factory crimp die unless you are shooting an autoloader.

FL sizer is used the first time cases are reloaded. Its very useful if you get brass from someone else who uses a 25-06 but doesn't reload, this brass will need to be Full length resized before it will work properly in your rifle.

Collet neck sizer- use on brass fired in your rifle. It simply resizes the neck by using a collet to squeaze the brass around a mandrel. Using one of these dies can help in accuracy as the brass is fireformed to your chamber, it is also faster to reload with because you don't have to lube the brass to use it. Another advantage is that it greatly increases the potential life of your brass. If the brass starts getting tight in your chamber, revert back to the FL sizer on your next reloading.

Bullet seater- does what it is, it seats bullets in the case.

Powder dipper- I use these for trickling powder, I've never actually used one to measuer powder.

Shell holder- hooks on to the rim of the brass and holds it on the press's ram.

Lee reloading data- tends to be on the conservative side, which is a good place to start, but a few manuals like Speer, Hornady, or Lyman would be a better place for reloading data.

RE: What dies do I need?
 

gee thanks a lot Briman...that was exactly what I was looking for...only thing is....they don't list the 25-06 on the website...I might have to call Cabelas and see if they got one set for me....thanks

RE: What dies do I need?
 

For reloading supplies MidwayUSA (www.midwayusa.com) is also worth a look.

RE: What dies do I need?
 

i just looked at www.10ring.com and they have it...both the press and dies are cheaper than anywhere I found!!