Shellholder for 284 Winchester Brass
 

What number shell holder should I use for284 Winchester?

Thanks

Tom

RE: Shellholder for 284 Winchester Brass
 

Standard .30/06-.308 shell holder. I think it is RCBS #2, but couldn't swear to it.

RE: Shellholder for 284 Winchester Brass
 

My Speer Reloading Manual states RCBS shell holder #3. Good luck.

RE: Shellholder for 284 Winchester Brass
 

As`stated the RCBS is a # 3 while the Lee is #2 and I beleive Redding is a #6

RE: Shellholder for 284 Winchester Brass
 

In general is it a good idea to match your dies and shell holders by manufacturer?

I figured that the shell holders were consistent across the board.

Tom

RE: Shellholder for 284 Winchester Brass
 

Yes, Tom, it is. This is becausethe thickness of the shellholder lip and the depth of the sizing chamber in the die are designed to give you the correct headspace when used together. Some makes of dies may have chambers that aretoo shallow or too deep when used with a shellholder of another make. Of course, this only applies when you screw the die into the press to the point that it touches the shellholder when the ram is all the way up.