Help with PBZ
 

I figured you guys would be the best to answer this since you probably do the most shooting.

I just put a new scope on my old 7mm-08 and I want to sight it using PBZ. What is the most efficient method to do this? I don't reload and I am shooting federal 140gr partitions which can get expensive.

Should I just sight in for 10-15 yards and then back up to 75, 100, 125 until I find the highest point then adust the scope so that mark is exactly +5 inches. Then continue out to find the range at -5 inches.

Thanks for the help.



[/align]

RE: Help with PBZ
 

Shoot 50, 100, 150 and 300 yards,from that data, you should be able to to guessitmate your speed from the ballistics chart and find the area where you drop 5". Just tell me your results, and type of rings on your gun, and I just plug it into my infinity program. Scope hieght is one of the most important numbers.

RE: Help with PBZ
 

Thanks BC

If you don't mind me asking, how much can you pick up that infinity software for?

When googleing PBZ I came across that.



[/align]

RE: Help with PBZ
 

Found it, thanks. I'll get back to you with that info.


[/align]

RE: Help with PBZ
 

I forget how much I paid for it. Its been a while. Its only version 4. Serra has a new version out.