May have screwed up?
I own a Ruger Mark II .338 Win mag(pre Hawkeye edition). The barrel was always making a little contact with the fron of the stock. So i decided to sand it away(composite stock). know the gun makes a rattle noise from uop front and the gun does not seem to shoot the same as it did before. I cannot get the same groups I was getting. Tell me what may have happened?? What do you think about me getting a new stock from ruger and starting over? What if I filled the forend with glass bedding to may be bring the back to close as original.
|
Some barrels need a little pressure from the stock in order to shoot well. Stick a couple of business cards under the barrel, about an inch back from the front of the stock. Add and/or subtract cards until you start getting your groups back. Then you can make a permanent shim or bed one.
|
Did you tighten the front action screw back properly? How about the sling swivel stud? Dont mean to seem insulting but its usually the simple things that make rattling noises :) I do stuff like that all the time.
|
All times are GMT -8. The time now is 12:27 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.