Go Back  HuntingNet.com Forums > Firearms Forum > Guns
Which Caliber for new Army Machine Gun?? >

Which Caliber for new Army Machine Gun??

Guns Like firearms themselves, there's a wide variety of opinions on what's the best gun.

Which Caliber for new Army Machine Gun??

Old 07-19-2018, 08:25 PM
  #1  
Nontypical Buck
Thread Starter
 
Join Date: Jul 2005
Location:
Posts: 1,693
Default Which Caliber for new Army Machine Gun??

Will the army select for their new machine gun? From the article, it looks like it's likely somewhere between .22 and 30 caliber. Maybe 6 or 7 mm?

http://www.foxnews.com/tech/2018/07/...tle-tanks.html

Last edited by elkman30; 07-20-2018 at 01:59 PM.
elkman30 is offline  
Old 07-20-2018, 11:09 AM
  #2  
Giant Nontypical
 
salukipv1's Avatar
 
Join Date: Jan 2008
Location: IL
Posts: 6,575
Default

6mm
6.5mm
7mm
salukipv1 is offline  
Old 07-22-2018, 07:38 AM
  #3  
Nontypical Buck
 
Nomercy448's Avatar
 
Join Date: Oct 2009
Location: Kansas
Posts: 3,902
Default

Seems like most signs are pointing to 6.5 Creed. For the application, I’m on board with it.
Nomercy448 is offline  
Old 07-22-2018, 09:13 AM
  #4  
Nontypical Buck
Thread Starter
 
Join Date: Jul 2005
Location:
Posts: 1,693
Default

Do you see the 6.5 meeting all of their enhanced requirements?
elkman30 is offline  
Old 07-22-2018, 10:37 AM
  #5  
Super Moderator
 
Join Date: Dec 2017
Location: texas
Posts: 1,201
Default

the current loads for the 6.5mm creed are loaded too no where close to the pressure levels listed in that linked article
they were talking double current pressure
hardcastonly is offline  
Old 07-22-2018, 10:44 AM
  #6  
Nontypical Buck
Thread Starter
 
Join Date: Jul 2005
Location:
Posts: 1,693
Default

It almost makes you think they're looking for a brand new caliber that can safely be loaded to such extreme levels so they eliminate the possibility of the new ammo being loaded into an existing rifle and avoid any accidents.

Last edited by elkman30; 07-22-2018 at 03:55 PM. Reason: Clarify
elkman30 is offline  
Old 07-22-2018, 03:28 PM
  #7  
Nontypical Buck
 
Nomercy448's Avatar
 
Join Date: Oct 2009
Location: Kansas
Posts: 3,902
Default

Which are...?

Lighter, smaller rifles, with lighter bullet weight. I’m ignoring all of these idiotic claims of telescoping case cartridges.

I’ve seen rumor the 6.8spc would be a contender in the squad rifle to replace 5.56 based mg’s, but it falls so far short on 7.62 based, I imagine it’s all speculation and desire, not tangible.
Nomercy448 is offline  
Old 07-24-2018, 05:20 PM
  #8  
Giant Nontypical
 
Join Date: Nov 2004
Posts: 5,425
Default

What about .243 and say, 75-80gr bullets loaded to about 3,200-3,400fps???
nchawkeye is offline  
Old 07-26-2018, 07:10 PM
  #9  
Typical Buck
 
Berserker's Avatar
 
Join Date: Jul 2017
Location: WI&UP
Posts: 751
Default

Machine gun.
Berserker is offline  
Old 07-26-2018, 08:39 PM
  #10  
Nontypical Buck
Thread Starter
 
Join Date: Jul 2005
Location:
Posts: 1,693
Default

The article listed some intriguing requirements. The new gun would have to:

1. Blast through enhanced armor at 2,000 feet away.
2. Have the new weapon will weigh less than 12 pounds and the new ammo to be 20 percent less than an equal brass case weight.
3. With the buttstock down, it would be 35 inches long or less.
4. The rate of fire will be 60 rounds per minute with 3-round burst for 15 minutes without a barrel change or cook-off.

There were more requirements listed but just these are pretty ambitious.
elkman30 is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.