Which Magnum for Long Range?
Not sure if I'll pull the trigger on this one or not, but researching a little...
I just pulled a Ruger M77 Hawkeye action (long action w/ Magnum bolt face) with a plan to shoehorn .458 Lott into it - a full 3.60" of 500grn glory. So then I got to thinking about doing a 7mm RUM barrel for it as well, to make it a little more practical. And thinking about that made me think about my nagging desire to do another 600-1000yrd hunting rig. If you were going to do a 3.60" magnum cartridge for 600-1000yrd killing of game - not just paper - what would you build? I'm thinking 300 or 7mm RUM right now, on a Rem 700 stainless action, either in walnut or a Mac A3 or 5, shilen tube. |
338 edge or Obrien will get better barrel life than the smaller rums.
RR |
A Nosler based 28 or 30. Or open the bolt face and do a 338 Norma.
A 3.6" action isn't long enough for a RUM, imo. |
Originally Posted by jeepkid
(Post 4254773)
A Nosler based 28 or 30. Or open the bolt face and do a 338 Norma.
A 3.6" action isn't long enough for a RUM, imo. Been thinking a bit about a 338 - I love the 338WM, but a little extra horsepower might be nice. Definitely a lot of bullet and recoil just for whitetails and coyotes, though. :action-smiley-099: :patriot: |
Rum uses a standard long action (magnum bolt face an extractor) it would be the same length as if you had a 300 win mag, 7mm Remington mag, 264 win mag, 30-06, .270 etc. Just like Jeep kid said the COAL of a RUM is too long for these actions. I noticed it when I got my 300 ultra but it isn't that much of a problem if any at all. Just an announce more than anything.
https://support.remington.com/Genera...hort_action%3F Honestly if you are building one just look for a used Savage action or savage rifle and buy a barrel. The route I went was I bought a Remington SPS 300 ultra and switched the stock out adn the trigger, that trigger is crap. The SPS shoot great at least from the ones I have had. I have not got to shoot the 300 yet do to I am still waiting on my Vortex scope. |
you can modify the action just a bit and get bottom metal to accept a good deal longer COL
RR |
Originally Posted by Ridge Runner
(Post 4254798)
you can modify the action just a bit and get bottom metal to accept a good deal longer COL
RR |
Originally Posted by Ridge Runner
(Post 4254798)
you can modify the action just a bit and get bottom metal to accept a good deal longer COL
RR |
Originally Posted by Brandon_SPC
(Post 4254801)
Can this be done by yourself or a Gunsmith has to do it?
an AICS bottom metal conversion will accept COL's of 3.775 the one I just measured came from seekins precision and inside the box measures 3.932, it requires fileing out .013" off the bolt stop, and that much taken off a protruding piece in the rear of the action though they are a bit pricey. RR |
7MM RM is a good caliber, the rest is up to you.
.......Reload if you want to be a "Wildcat" !!! |
All times are GMT -8. The time now is 06:39 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.