H&R slug gun front sight
 

i have the tracker 2 slug gun, it isnt drilled and tapped for a scope, but it has the rifled sights, which i dont mind, since i probaly wont get a shot past 100 yards, which rifled sights will be fine for me, but i dont like that the front sight is black, is there a way i could take a fiber optic from my bow sight pin and melt it or glue it on there? would it work? i also have a ML with rifled sights, but i dont use em cause i have a scope on it, could i have a gun smith take them off and put them on the slug gun? if i could would it probaly cost alot?
thanks
mike

RE: H&R slug gun front sight
 

Replacingthe front site would work but result in re-sighting I figure...Mike - I wonder if a florecent (or bright paint?) would be enough to give you what you want?....just a thought....

RE: H&R slug gun front sight
 

yeah that would work, but i will let my dad do it:Dsinch i dont want any runs, should that be bright enough.

RE: H&R slug gun front sight
 

the reason i mentiond replaceing the sights, is cause i have both the front and rear, from my ML, i would just have to ge em off, but i think i am gonna pain it.
thanks

RE: H&R slug gun front sight
 

I think paint will get you close....you know how it goes when you start ripping sights off guns...

I have a thompson center Hawken that I had a bright idea with...and now I can't figure out how to get a working site back on the gun...Good Luck!