![]() |
RE: Shotgun Accuracy
I used to shoot regular slugs outta my rifled barrel. But after about 3 shots accuracy declines drastically due to all the lead in the rifling. i'd shoot sabots accuracy will be much better
|
RE: Shotgun Accuracy
ORIGINAL: life_is_short_hunt_hard since you have a rifled barrel... you might also want to consider the Hornady SST slugs. i shoot these out of my 870 epress and can leave all three shots within a 1 and a half inch group at 50 yards with open sights. |
RE: Shotgun Accuracy
first of all and MOST IMPORTANTLY, you need to find out what twist rate your barrel is.Rem. barrels are usually a 1:28 twist where as Hastings barrels are a 1:34 twist. If your twist is under 1:28, forget about the high speed, light bullet slugs, they simpley will not stabalize and will shoot all over the place. i know slugslike the core lokts and hornadys SST's look pretty, but if you dont have the proper twist rate, dont waste your $$$. On my setup, the bore sizehastings and rem. buckhammer slugs shoot best with the attached sabot tail. witha red dot sight i can shoot 2" groups @ 50yds all day. also, worth a mention are the brenneke golds, they have shot well out of anyslug gun for me.
|
RE: Shotgun Accuracy
I have a 20 in 2 3/4 and I use slugs. Groups great at 75 yards with ironsights.
|
RE: Shotgun Accuracy
ORIGINAL: ReDoT first of all and MOST IMPORTANTLY, you need to find out what twist rate your barrel is.Rem. barrels are usually a 1:28 twist where as Hastings barrels are a 1:34 twist. If your twist is under 1:28, forget about the high speed, light bullet slugs, they simpley will not stabalize and will shoot all over the place. i know slugslike the core lokts and hornadys SST's look pretty, but if you dont have the proper twist rate, dont waste your $$$. On my setup, the bore sizehastings and rem. buckhammer slugs shoot best with the attached sabot tail. witha red dot sight i can shoot 2" groups @ 50yds all day. also, worth a mention are the brenneke golds, they have shot well out of anyslug gun for me. dd |
RE: Shotgun Accuracy
While we're discussing slugs, if any of you have Brenneke brand slugs, DON'T SHOOT THEM UNTIL YOU HAVE CHECKED THEM OUT!!!! I just opened the new issue of field and stream and they have a recall in there for certain brenneke slugs. I won't try to go into specifics. I don't want to make a typo and cause someone to get hurt thinking that theirs are ok. Just please check it out, look it up on the net or open up field and stream and check it out. I'm also glad to see that I"m not the only one who loves the federal barnes slugs.
|
RE: Shotgun Accuracy
ORIGINAL: ReDoT first of all and MOST IMPORTANTLY, you need to find out what twist rate your barrel is. Rem. barrels are usually a 1:28 twist where as Hastings barrels are a 1:34 twist. If your twist is under 1:28, forget about the high speed, light bullet slugs, they simpley will not stabalize and will shoot all over the place. i know slugs like the core lokts and hornadys SST's look pretty, but if you dont have the proper twist rate, dont waste your $$$. On my setup, the bore size hastings and rem. buckhammer slugs shoot best with the attached sabot tail. with a red dot sight i can shoot 2" groups @ 50yds all day. also, worth a mention are the brenneke golds, they have shot well out of anyslug gun for me. Lastley, can you adjust the trigger on the 11-87. I appears to be set at around 6-7 pounds. |
RE: Shotgun Accuracy
UPDATE:
I decided to head down to my local gunsmith today, I wasnt sure how to disassemble completely and wanted to give it a good cleaning, plus I wanted him to adjust the trigger. As he was showing me how to remove the trigger assembly, the feed latch fell out onto the floor. He said this is supposed to be tacked (soldered) to the receiver. Not sure if that affected the accuracy or not, it is not a good thing to have happen. Luckily I found out before heading to the range again. |
RE: Shotgun Accuracy
ReDoT, interesting findings concerning twist rate of your barrel. Normally, the faster the twistrate of the barrel, the more, not less, easily you stabilize bullets. I had a T/C Thunderhawk muzzleloader with a 1:34 twist, and was able to shoot the .44 cal. saboted Hornady XTP 300 grain bullets really well. My friends shooting Hawkins, with the 1:48 twist couldn't hardly stabilize anything but real light (short) bullets, and roundballs. Guns that shoot balls the best, are normally really slow twist guns, like Kentucky long rifles with 1:66 twist rates. I am sure you can over stabilize a bullet with a really fast twist rate, just not sure how fast is too fast. The 1:28 twistrate is fantastic. Pretty sure all Knight muzzleloaders, and most sabot designed guns sport a twist rate similar to the 1:28.
|
RE: Shotgun Accuracy
ORIGINAL: DoctorDeath ANY IDEA WHAT THE TWIST RATE IS ON AN ITHICA DEER SLAYER IS? dd |
| All times are GMT -8. The time now is 10:44 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.